Electric Hob Repair: What to Do When Your Cooktop Stops Working
If your electric hob suddenly stops heating, you’re probably wondering if it’s a quick fix or a call to the pros. The good news is most hiccups are easy to spot, and you can often save a few pounds by doing a little troubleshooting yourself. Below we break down the most common faults, cheap DIY steps, and the point where you should pick up the phone.
Typical Electric Hob Problems
Even a well‑maintained cooktop can develop a few tell‑tale issues:
- One or more burners won’t heat. This usually means a faulty heating element or a loose connection.
- All burners are dead. Often a tripped safety switch or a broken fuse.
- Uneven heating. A cracked glass top or a failing temperature sensor can cause hot spots.
- Clicking or humming noises. The igniter may be stuck, or the control board could be on its way out.
Knowing which symptom you have narrows down the fix dramatically.
DIY Checks Before You Call a Technician
1. Reset the power. Turn off the hob at the wall socket, wait 30 seconds, then switch it back on. A simple reset can clear a tripped safety circuit.
2. Inspect the glass. Look for cracks or chips. Even a small fracture can affect heat distribution and may need a replacement panel.
3. Test the burners. Swap the non‑working burner with one that works. If the problem follows the burner, you’ve got a bad element. If it stays on the same side, the issue is likely wiring or the control board.
4. Check the fuses. Most electric hobs have a fuse in the plug or near the circuit board. A quick visual check for a blown filament can save you a service call.
These steps take under ten minutes and often point you straight to the faulty part.
When to Call a Professional
If you’ve tried the above and the hob still won’t heat, it’s time to bring in a specialist. Here’s why a pro can be worth it:
- Electrical safety. Working inside the control board involves live wires. A certified technician follows strict safety protocols.
- Correct part identification. Professionals have access to genuine replacement elements and know the exact model specs.
- Warranty protection. Many repairs are covered under a warranty if done by an authorized service.
At Hinckley Home Appliance Repair Services we handle electric hob repairs from start to finish – diagnosing the fault, ordering the right part, and getting your kitchen back in action quickly.
Cost Expectations
Typical repair costs in the Hinckley area range from £60 for a simple fuse replacement to £180 for a new heating element and labor. A full control board swap can run £250‑£350. We always give a clear quote before any work begins, so there are no surprise charges.
Remember, the longer a faulty hob sits idle, the higher the risk of further damage. A quick repair not only restores cooking convenience but can also prevent a small issue from becoming a costly replacement.
Got a stubborn electric hob? Try the quick checks above, and if you’re still stuck, give Hinckley Home Appliance Repair Services a call. Our friendly technicians will have your cooktop cooking again in no time.
26 October 2024 ·
0 Comments
If your electric hob has stopped working, this guide provides practical steps to help you troubleshoot and resolve common issues. From checking for power supply problems to inspecting the control panel, you will find useful tips to fix your hob at home. Understanding these basics might save you a costly call to the repairer. Learn about common problems, safety tips, and the simple steps you can take to get your hob back in action.
Read more
